Finding water on the floor outside the shower?
Water outside the enclosure usually means a worn sweep, a gap at the door edge or failed silicone - but not always. Here is what to do now, and how to tell where it is really coming from.
Request an estimateRule out the enclosure first
Run a simple test. Dry the floor, run the shower with the door closed, and watch where water first appears. The spot it shows up points at the failing part - sweep, edge, or joint.
Check the usual parts. A split or missing bottom sweep, hardened edge seals and separated silicone joints are the most common causes, and all are repairable.
Consider other sources. If water appears when the shower is off, or keeps coming with the enclosure dry, the cause may be a supply line or drain - that is plumber work, not seal work.
If it is the enclosure
Shore Glass Seal replaces worn seals and sweeps, renews failed silicone and adjusts door hardware. Send photos of the full enclosure and the spot where water appears. We review every request before confirming the appointment and final price.
What to send with your request
- A full view of the shower enclosure.
- A close-up of the bottom sweep, both door edges and the joints.
- The wet spot itself, taken right after the shower runs.
Based in Howell, serving Ocean and Monmouth counties. The estimate form checks your service address and shows any travel fee. Every request is reviewed before the appointment is confirmed.
Do I need a whole new shower door?
Not necessarily. If the problem is a worn sweep, seal or failed silicone, a targeted repair may be enough. Photos and an assessment help establish what your enclosure needs.
What if it keeps coming back?
Water that returns after parts are replaced points to alignment, enclosure design or a non-enclosure source. We would rather tell you that than keep selling parts.
Can you quote from photos?
Photos help us review the request. Use the estimate form for a starting price; the appointment and final price are confirmed after review.
Or call 732-314-6734.